How to Use 180° Micro Servo Motor
You can move the motor by specifying the rotation angle. It can perform complex movements like moving a robot or dispensing water to plants as needed. The brown wire is GND, the red wire is the power supply's +, and the orange wire is the signal wire.
About the Module
You can rotate the red circle part in the photo. It can move from 0° to 180° according to the signal.
About the Included Mount
You can attach the included servo horn (white mounting part) to the rotation axis of the 180° Micro Servo Motor.
Specifications
| Voltage | 5V |
|---|---|
| Angle Range | 0～180° |
| Control Pulse | 500～2500μsec |
| Torque | 1.3kgf・cm |
| Operating Speed | 0.12 sec / 60° |
| Temperature Range | -10～50℃ |
| Size | 23 x 13 x 30 (mm) |
| Weight | 9g |
Connection
Connect the 180° Micro Servo Motor to the SPACEBLOCK microcontroller board using jumper wires (male-male) as follows:
- Connect the orange wire of the servo motor to the PWM compatible pin of SPACEBLOCK
- Connect the brown wire of the servo motor to the GND pin of SPACEBLOCK
- Connect the red wire of the servo motor to the 5V pin of SPACEBLOCK
※The image shows the signal line connected to pin A0. PWM compatible pins are A0, B0, A10, B8.
※5V and GND can also be inserted into the pins with the same notation on the SPACEBLOCK microcontroller board.
Usage
Command the angle you want the 180° Micro Servo Motor to move using blocks. You can use the dedicated blocks in the 'Output' category > 'Servo Motor' in the project.
For detailed usage of the blocks, click here
Move the servo to ~°